Bravo ax1yz: special car "la cavia elettronica"

ax1yz

L'igo9 non ti conviene perchè i driver per il gps non sono ancora stabili, tempi molto lunghi prima di fare il fix dei satelliti <_<

sepher

ax1yz ha scritto:

Sepher Hello, sorry but I do not write English :azz:

and use "google translator" :lau:

Thanks for the compliments :rolleyes:

, if you want to translate the guides for your friends, no problem, go ahead :ok:

.

The steering wheel should not be connected in parallel because the voltage sent from the computer take precedence over the one-body of the car, I had to try, but then I gave up in the radio because I have everything I need, so I excluded B & M .

I'm sorry I've never bought CAN bus interface because they cost too much, and are not standard

:ciao:

@ simon_27, corry88, jefe75 e si specialmente questo G2216

Ale ma ci facciamo dare la percentuale, che ne dici :shifty:

Hi ax1yz,

Hmm, I'll try google translator

Thanks, I translated your tutorial in Turkish Bravo Fans forum hoping many of us profit from your know-how.

Later I figured it out, also. Tested the HU using a PC power supply and found out that the unit acts as a constant current source (which is very low indeed ) on SWC pins. So as you said, either the body computer or the HU will overload or suppress other. So, in case I cannot find a suitable can-bus adapter I will develop a circuitry that would probe the lines and translate the button presses to head unit. A simple PIC MCU with analogue input will be enough.

Again thank you very much for the information, patience and of course your comprehension for me typing in English.

Best regards,

momonedusa

Hi sepher

if you wish you could make us an official introduction, so everyone can give you his wellcome..

You can open a new presentation topic in tis area (viewforum.php?f=2)

:wel:

For your problem i think it is better to discuss here viewtopic.php?f=122&t=20300&p=650993#p650993 which is the specific topic for steering wheel controls. :ok:

sepher

momonedusa ha scritto:

Hi sepher

if you wish you could make us an official introduction, so everyone can give you his wellcome..

You can open a new presentation topic in tis area (viewforum.php?f=2)

:wel:

For your problem i think it is better to discuss here viewtopic.php?f=122&t=20300&p=650993#p650993 which is the specific topic for steering wheel controls. :ok:

Hi momonedusa,

Job done! Thanks for the link.

Thanks for your recommendation. I gathered some useful information on relation between Chinese branded head units and Pioneer. I will try to explain my pre-mature conclusions on that topic.

Regards,

spa856

Complimentoni per le modifiche all'auto.
Io già sto in crisi per installare l'autoradio nuova...e da norauto mi hanno chiesto 200 euro di manodopera....
:incazz:

ax1yz

ops... scusa spa856, ho visto solo oggi la tua risposta, grazie

200€, se sono solo per sostituire l'autoradio sono tanti, se invece devi aggiungere moduli o cablaggi vari... bisogna valutare

Comunque oggi con quasi 25000 Km sulle "gomme :lau:

" e il secondo compleanno della :bravo1981:

, avevo un Immagine

per oggi, se non fosse per gli incompetenti dell' SDA :azz:

non sanno leggere neanche il civico di una via :incazz:

CuoreNero80

Metti luminoso anche quello Anto

Augurozzi

è la stessa cosa mia? :shifty:

Picobravo

spa856 ha scritto:

Complimentoni per le modifiche all'auto.
Io già sto in crisi per installare l'autoradio nuova...e da norauto mi hanno chiesto 200 euro di manodopera....
:incazz:

Se posso dirtelo non andare da Norauto...a me di manodopera me ne hanno chiesti 80 presso un installatore autorizzato...fai un pò di preventivi in giro